Honda atc 350x cam chain block2/29/2024 What type material is the cylinder? Can it just be bored and hone without other work needed to be done to it?Ĭan the head be milled down for higher compression? How much can it be milled safely with the big bore piston that has a dome? Can you use the stock head with the bigger piston?īeatrice told me that a cam, piston and carb would run $135 and would make a big difference in power. Is this true? Another said it would cost $250 if it was Nickelsel plated. One shop told me it would have to re sleeved. I called around to find out who can bore and hone. I see there is a 54mm piston with a 9:1 ratio. I have been doing some research to see how I can make some more power with this bike. The screw that is left of the idle screw is that the air mixture screw? No matter how much I turned it, it didn't make a difference either no load or under load. It seemed like the carb would load up and idle down and die. After driving it around for half of the day the idle seamed to get better. We took it out on the lake last sunday and it did pull the shanty but in low 1st gear. I would get it to idle and then when I put it in gear it would die. When I got the carb back on the idle was all over the place. ![]() ![]() I completely disassemble it and cleaned out all the jets with seafoam. So my first question is it a 16 mm or a 22mm carb that came with the 110. The carb that was on it looks like its off a 110. We went through the bike and fixed many little things that had been neglected. My neighbor and I bought it to pull an ice shanty.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |